This is a 6 inch panel wire that is used to make the jump between panels. If you are using a zig-zag configuration, or if you need a little extra cable to get from your controlling mechanism to the first panel in a daisy chain, try a 15" or 24" cable.
A typical use case scenario is pictured here as a depiction of 6 panels being daisy chained and zig-zagged off of one port of an Octoscroller or Pi Hat. The red lines represent the 6 inch / short wires that are included with each panel purchase or on this page. The green lines represent a longer cable.
If you are building a bigger panel, and every row is making a home run, the following chart tells you what additional cables you will need to make a jump from a computer or controller located at the center vertical height of your panel to each of the panel rows.
For help building out a panel, please take a look our Matrix Buildout Configurator and Calculator. It will create a plug and play solution for building a panel to your specifications.
- Length: 15cm / 6"
- Wire Count: 16
- Quantity 1